Having a problem and I'm wondering if you guys can help me figure it out:
I recently got a new monitor, a ViewSonic VX2370Smh-LED IPS. I also had to get a new DVI cable since this one only shipped with HDMI. That finally arrived today, so I got it hooked up excited to do downsampling again, but when I set anything to the new res the monitor loses the signal.
I'm aware that non-dual link and knock off DVI cables do not have the bandwidth necessary to DS, so I picked a more expensive monocable DVI-D cable that I was pretty confident would be sufficient, especially since the generic one I got with my last monitor 6 years ago worked just fine with DS. I'm hopeful that that isn't the issue.
I'm going to do a total driver sweep and start over incase that might be an issue. Not really sure what other info to give. Any suggestions?
FIXED: The driver sweep did take care of it.